Arducam 16MP Autofocus Camera Module Raspberry Pi or Jetson Nano / NX

SKU: KE3023

Specfication & Comparison Chart

Sensor: Sony IMX519 stacked, back-illuminated sensor 16 megapixels 1.22 µm × 1.22 µm pixel size7.103 mm diagonal (Type 1/2.534)

Output: RAW10/8, COMP8

Lens: Autofocus; f/1.75; EFL: 4.28; FoV: 80°; Focus Range: 10 cm ~ infinite

IR cut Filter: Integrated

Tripod mount: 1/4”-20

Enclosure: ABS, also compatible w/ camera module v1 & v2.

Ribbon Cable Length: 150mm

Safety instructions

Before connecting, you should always power the Raspberry Pi off and remove the power supply first.

Make sure the cable on the camera board is locked in place.

Make sure the cable is correctly inserted in the Raspberry Pi board’s MIPI CSI-2 connector.

Avoid high temperatures.

Avoid water, moisture, or conductive surfaces while in operation.

Avoid folding, or straining the flex cable.

Avoid cross-threading with tripods.

Gently push/pull the connector to avoid damaging the printed circuit board.

Avoid moving or handling the printed circuit board excessively while it’s in operation.

Handle by the edges to avoid damages from electrostatic discharge.

Where the camera board is stored should be cool and as dry as possible.

Sudden temperature/humidity changes can cause dampness in the lens and affect the image/video quality.

*Support NVIDIA Jetson board