Arduino Ethernet Shield 2 W5500 - Original Made In Italy Code: A000024

NOTE: TIDAK MENERIMA KLAIM ATAU KOMPLAIN DI LUAR SISTEM SHOPEE

SKU: KF2026

Code: A000024

Operating voltage 5V (supplied from the Arduino Board)

Ethernet Controller: W5500 with internal 32K buffer

Connection speed: 10/100Mb

Connection with Arduino on SPI port

PoE module features as follows:

IEEE802.3af compliant

Input voltage range 36V to 57V

Overload and short-circuit protection

12V Output

High efficiency DC/DC converter: typ 85% @ 80% load

1500V isolation (input to output)

The Shield does not come with a built in PoE module, it is a separate component that must be added on. Arduino communicates with both the W5500 and SD card using the SPI bus (through the ICSP header). This is on digital pins 10, 11, 12, and 13 on the Uno and pins 50, 51, and 52 on the Mega. On both boards, pin 10 is used to select the W5500 and pin 4 for the SD card. These pins cannot be used for general I/O. On the Mega, the hardware SS pin, 53, is not used to select either the W5500 or the SD card, but it must be kept as an output or the SPI interface won\'t work.

Note that because the W5500 and SD card share the SPI bus, only one at a time can be active. If you are using both peripherals in your program, this should be taken care of by the corresponding libraries. If you\'re not using one of the peripherals in your program, however, you\'ll need to explicitly deselect it. To do this with the SD card, set pin 4 as an output and write a high to it. For the W5500, set digital pin 10 as a high output.

The Shield provides a standard RJ45 Ethernet jack.

The reset button on the Shield resets both the W5500 and the Arduino Board.

The Shield contains a number of information LEDs:

ON: indicates that the Board and Shield are powered

13 is the Arduino standard built in LED

ACT: flashes when RX or TX activity is present

LINK: indicates the presence of a network link and flashes when the Shield transmits or receives data

In this picture below we have tagged the yellow ACT, the green LINK,, the 13 Built in LED and the ON LED.