ESP32-C3 ESP32C3 Wifi Bluetooth CORE Development Board Micropython - Classic

ESP32C3-CORE Development Board

The classic model (version with TTL serial port to USB) must install the CH343 driver to download the firmware normally. The default CDC driver can only print the log, but the download will fail if the speed is too slow. drive portal.

The new model (USB direct connection) can be burned directly without installing the driver. You can use Luatools to burn normally, but cannot use LuatIDE. There is no difference except that the firmware with the word USB needs to be selected when burning.

1. Product description

The CORE ESP32 core board is a core board designed based on Espressif ESP32-C3. The size is only 21mm*51mm. The edge of the board is designed with stamp holes, which is convenient for developers to use in different scenarios. The core board supports UART, GPIO, SPI, I2C, ADC, PWM and other interfaces, which can be selected according to actual needs.

2. Hardware resources

Dimensions length and width 21mm*51mm

1 channel SPI FLASH, onboard 4MB, support up to 16MB

2-way UART interface, UART0~UART1, among which the download port is UART0

6-channel 12-bit ADC, maximum sampling rate 100KSPS

1 low-speed SPI interface, support master mode

1 channel IIC controller

4-way PWM interface

15 external GPIO pins, which can be reused

2 way SMD LED indicator

1 channel reset button + 1 channel BOOT button

1-way USB to TTL download debugging port

2.4G PCB Onboard Antenna